up to 132 kW Ring Type Terminal
The C-series switches not only represent the classic cam switch by Kraus & Naimer, but the switches are also applicable as main switches.
Special Contact developments such as 9 pole ON/OFF switches or in installations with vertically limited space makes the switch an all-purpose solution. Depending on the series the switches have easily accessible and captive terminal screws or with bolt terminals for ring type cable lugs and protective covers.
The switches of the C-series offer a solution for most cam switch/main switch applications.
lu/lth [A]: 315
Utilization Category (3 x 380 V – 440 V):
AC-23A [kW]: 132
AC-3 [kW]: 55
According to IEC 60947-3, EN 60947-3, VDE 0660 part 107.
2, 3, 4, 6 and 8 pole
- Change Over Switches
3 and 4 pole
The Panel Mountings are well used mountings which cover wide application ranges.
They consist of two main groups.
- The two/four hole mountings, which are fixed by (2/4) screws around the center shaft hole.
- While at the single-hole mountings the shaft hole is used for fixation.
The two/four hole mountings provide several variations which make them fit for all tasks.
Base Mounting is used to fix a switch at the rear side, therefore it is the commonly used mounting for larger distributing cabinets.
The switch can be mounted at the base panel by two or four screws and also by 'Snap-On'. For this mounting, several door clutches with or without padlock are available.