Base mounting


Base Mounting
Base Mounting is used to fix a switch at the rear side, therefore it is the commonly used mounting for larger distributing cabinets.

The switch can be mounted at the base panel by two or four screws and also by 'Snap-On'.
For this mounting, several door clutches with or without padlock are available.

Base Mounting
Mounted with screws For 'Snap-on' base mounting on tracks acc. to EN50022; IP40
4 hole mounting 2 hole mounting With square escutcheon plate With escutcheon plate for 45mm standard knock-out With escutcheon plate for 45mm standard knock-out, adjustable in height With circular escutcheon plate for Ø46mm knock-out
Standard; IP40 With integrated simplified door clutch; IP65 With circular escutcheon plate for Ø46mm knock-out; IP40 Standard; IP40 With integrated simplified door clutch; IP65
VE VF VE4 VE22 VF22 VE1 VE2 VE21 VE3